2 hp 120 V 1500W industrial Electric Servo Motor Variable Speed Controller lathe

2 HP 1500 Watt Computer Controlled Servo Motor. For any range between 300 to 3,500 RPM. Note: the maximum distance between control unit and motor is 28 inches. Runs on typical 110 to 120 volt AC. Supply's (220V - 250V AC single phase is available by request). The 2022 models are here. A complete servo motor as seen in image one.

A 2-22 stand alone and. Custom built servo motor driver with built in overload protection and internal variable speed control. Toothed L050 pulley not included. Note I can cut, broach and fit any pulley you chose at additional cost.

One 1,500 watt (2 HP) servo motor. One 2022 customized servo motor. Controller with internal speed control.

And a thermal overload system. Motor programming + spindle speeds and Reverse. The motor speed can be programmed to operate in any range chosen by the user. Between 300 and 3,500 RPM's.

The full range of speed (RPM's) can also be controlled with just the speed control knob. Only requires a few easy steps. Reverse is simple, just hold the yellow button for a few seconds. Includes the ability to set bottom and top RPM range separately. In other words you can program the system to run the spindle at any speed or range of speeds you choose (see below).

Slowest speed achievable: Motor 200 RPM. (Below 300 is not recommended).

Highest speed: 3,500 RPM. Can be programmed to reach 5,000 RPM. This is seriously not recommended. It is also dangerous as in parts could fly across the room causing serious bodily injury even death.

Setting above 3,500 RPM also voids. Soft start is programmable and will be set as soft as possible when you receive this motor. This program is very effective in reducing drive belt wear etc. Braking strength is also programmable and will be set as low as possible. Safe turn on system where the speed control knob must be in the full counter clockwise (stop) position when turned on.

When turned on the self. System checks for faults and will not allow the motor to turn on until the speed control knob is turned all the way to stop first. Control unit has the ability to stop the motor or what ever it is turning in 2 different locations with external hall effect sensors not included. To communicate with any CNC.

Use at your own risk. RPM: 100 to 3,500 RPM in 100 RPM increments. This listing is for what is seen in the primary image. It will include printed programming instructions. Have this on my Taig lathe with 5c head stock and wow!! Can't find this anywhere else. Large flat rate box and to USA only.

This item will be is strict. Applied to this item when it was listed. See details, what's covered and for how long etc below. If found to be abuse or missing the.

Or demos that I have from previous builds. Additionally original packaging such as Styrofoam package inserts must be used to return these parts.

Ask lots of questions before ordering. Do not worry about missing this item. If you miss it, I will get more soon. This item is in the category "Home & Garden\Tools & Workshop Equipment\Power Tools\Lathes". The seller is "thecustomcrafter" and is located in this country: US. This item can be shipped to United States.

Minimum Spindle Speed: 300 RPM
Phase: One Phase
Machine Type: Servo Motor
Power Source: Home electric outlets
Maximum Spindle Speed: 3.500
Suitable For: Aluminum, Brass, Cast Iron, Iron, Metal, Plastic, Stainless Steel, Steel
Brand: The Custom Crafter
Model Year: 2022
Type: Lathes, milling machines, band saws and more
Control: Programmable Speed Control, Manual
Manufacturer Warranty: See description.
Voltage: 110 V, 115, V 120 V
Model: Internal 1,500 Watt with 9 amp thermal