Electric motor GE 3HP 3PH 1750 rpm Industrial motor

  

Electric motor GE 3HP 3PH 1750 rpm Industrial motor. The highest quality, like new, USA made cast iron compressor duty motor you will ever see and in like new condition.

Totally dismantled, gone through and cleaned(though it was pretty much pristine inside), sandblasted, primed and painted. The bearings are perfect and are huge!! On the shaft output the bearing is just under 3 OD!! Weighs 95 lbs with pulley shown. The rotor and armature are massive.

You would think this was 15- 20 horse motor. Although an ODP(open drip proof) motor it stays clean inside due to unique stamped steel "pans" at the bell housings that deflect dirt and dust.

Never seen that before in any motor. Stainless steel etched motor nameplate. If not abused this motor would probably be in service 100 yrs from now! This item is in the category "Business & Industrial\Industrial Automation & Motion Controls\Electric Motors\General Purpose Motors".

The seller is "normstavin" and is located in this country: US. This item can be shipped to United States.

1. Model: Industrial motor
2. Brand: GE
3. Rated Load (HP): 3
4. Current Type: AC
5. Nominal Rated Input Voltage: 230 V
6. AC Phase: Three Phase